Derailed wardrobe doors, tracks and heavy mirror panels
Wardrobe sliding door repair in Singapore is S$160 to S$280 for bottom and top rollers from Hafele, OPK, Excel or a carpenter carriage. A bent aluminium track from 1.5m to 3.0m is S$240 to S$420. Re-hanging a 35kg to 60kg mirror door with anti-jump clips and a soft-close damper is S$280 to S$550. A full 2-door or 3-door overhaul is S$380 to S$680.
trusted by 500+
The roller, the track, or a door that has jumped
A scraping door is usually a flat roller. A door that leans out at the top has left the track. A 50kg mirror that can leave the track is a safety job, not a new wardrobe.
| What you see | Likely cause | What to do first / typical cost |
|---|---|---|
| Door scrapes or sticks halfway | Bottom or top roller is flat | Hafele, OPK, Excel or carpenter carriage: S$160 to S$280 |
| Track is dented or the door hops | Aluminium track is worn | 1.5m to 3.0m flush track: S$240 to S$420 |
| Full-height mirror has come out | Anti-jump clip is missing on a 35kg to 60kg door | Re-hang, clips and soft-close: S$280 to S$550 |
| Every door is out of line | Track, rollers and soft-close are all tired | 2-door or 3-door overhaul: S$380 to S$680 |
2026 wardrobe door bands
The carcass stays. A new built-in wardrobe of this size is often about S$3,000. The overhaul is the hardware, at about 15 percent of that. Hinge and gas-strut parts for swing doors are in the Blum, Hafele and Excel guide.
| Job | 2026 SGD band | Inclusions |
|---|---|---|
| Bottom and top roller replacement | S$160 to S$280 | Hafele, OPK, Excel or carpenter bottom-rolling and top-hung carriages on a stuck or scraping door. |
| Aluminium bottom track, 1.5m to 3.0m | S$240 to S$420 | Cut out a bent or worn double or triple track and fit a flush replacement. |
| Heavy mirror or glass door re-hang, 35kg to 60kg | S$280 to S$550 | Re-hang, anti-jump safety clips and a soft-close damper. Aimed at doors that can derail onto a bed or a child. |
| 2-door or 3-door track, roller and alignment overhaul | S$380 to S$680 | Track, rollers, soft-close and alignment on a built-in wardrobe. About 15 percent of a S$3,000 new wardrobe. |
Derailed wardrobe doors, tracks and heavy mirror panels: access and preparation
Derailed wardrobe doors, tracks and heavy mirror panels is hardware and carcass work when the kitchen or wardrobe layout stays put. Hinges, runners, a door leaf in the same opening, and a sectional under-sink rebuild do not need an HDB renovation permit. A new layout, a hacked wall, or a moved gas point does.
Brand-matched hardware takes longer to identify than a generic cup hinge. A soft carcass under a leak is a different visit from a dry door that only needs alignment. Condo management may care about noise and disposal of the old board. Landed houses add stair cupboards and taller doors.
- Photo of the hinge or runner stamp
- Count the doors or drawers that fail
- Note a leak under the sink if the board is soft
- Clear the work area
- Say HDB, condo or landed
Plan Derailed wardrobe doors, tracks and heavy mirror panels
Read the stamp before ordering a look-alike hinge or runner.
Protect the floor and empty the cabinet that has to come open.
Replace the failed part. Do not rebuild the kitchen because two doors sag.
Check that doors close, drawers stay on the runner, and overhead flaps stay up.
- Bottom and top roller replacementS$160 to S$280
- Aluminium bottom track, 1.5m to 3.0mS$240 to S$420
- Heavy mirror or glass door re-hang, 35kg to 60kgS$280 to S$550
- 2-door or 3-door track, roller and alignment overhaulS$380 to S$680
| Access | HDB | Condo | Landed |
|---|---|---|---|
| Permit | Layout unchanged: no HDB permit. A new kitchen layout is V On Construction. | MCST quiet hours and a lift for sheet material. | No HDB permit. A structural opening is still not carpentry. |
| Board | HDB kitchens are often 16mm particleboard with a melamine face. | The same moisture problem, plus a management rule on debris. | Older landed joinery may be solid timber. Match the repair to the timber, not to a flat-pack hinge. |
| Hardware | Count hinges and photograph the angle before anyone buys a set. | Service lifts close early. Book the slot before the parts arrive. | Tall doors need a second person. Do not hang them alone. |
- Photo of the hinge or runner stamp
- Count the doors or drawers that fail
- Note a leak under the sink if the board is soft
- Clear the work area
- Say HDB, condo or landed
Frequently Asked Questions
How much is a wardrobe roller replacement?
Bottom and top rollers for a stuck or scraping sliding door are S$160 to S$280, including Hafele, OPK, Excel and carpenter carriages.
Can a derailed mirror wardrobe door be re-hung?
Yes. A 35kg to 60kg door is re-hung with anti-jump clips and a soft-close damper for S$280 to S$550. The glass stays if it is intact.